Fairland PIONEER PH18L Notice D'installation Et Conseils D'utilisation page 23

1,50 m
1,50 m
VOLUME 2 VOLUME 2
VOLUME 1
VOLUME 0
1,50 m
1,50 m
2,00 m 2,00 m
Volume 0: Safety extra-low voltage* (SELV) < 12 V alternating or 30 V direct + the equipment must be IPX8 rated (dust-free, water-
proof).
Volume 1: Safety extra-low voltage* (SELV) or equipment placed inside an IK07 rated cabinet that when opened cuts the power
supply to the equipment + equipment rated IPX5.
Volume 2: Safety extra-low voltage* (SELV)* or dedicated 30mA differential circuit breaker on the line or separation by an isolating
transformer + equipment rated IPX2.
*transformation source must be located outside volumes 0, 1, 2.
FAIRLAND PIONEER heat pumps are IPX4 rated, this means that in France they can be situated within volume 2 subject to the
condition that the power line is protected by a 30mA differential circuit breaker. Failing this, they must be placed outside volume 3.
It must be possible to disconnect the active poles (phase and live) from the power supply. The unit should be disconnected from its
poser supply systematically prior to any technical intervention.
Should the cable be damaged, it must be replaced by the manufacturer, its after sales service or other similarly qualified personnel
in order to avoid any risk of electrocution.
The device must be protected at the head of its power line by a thermo-magnetic circuit breaker the amperage of which is rated to
suit the power consumption of the product. (See page 26).
In the event of a power cut while the heat pump is running, the heat pump will start up automatically when the power comes back
on.
If the heat pump will remain inactive over a long period of time, cut the power supply and drain the heat pump by closing the 2
valves on the inlet and outlet lines and disconnecting the water supply hose.
Mack sure that the on/off switch is out of reach of children.
2012/04 - Indice de révision : C - Code : 0033436
23/32