Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING
Read this manual carefully before using the
machine, for your own safety.
SAFETY INSTRUCTIONS
When using the machine, always observe
the enclosed safety instructions as well as
the additional safety instructions.
The following symbols are used throughout
this manual:
Denotes risk of personal
injury or damage to the tool.
ELECTRICAL SAFETY
Always check that the power
supply corresponds to the
voltage on the rating plate.
DESCRIPTION
Your hammer drill has been designed for
drilling in wood, metal, plastic, stone and
concrete.
1 On/off-switch
2 Lock-on button
3 Switch hammer drill function
4 Chuck
5 Side handle
6 Depth stop
Inserting and removing a drill
n
Open the chuck (4).
n
Insert the drill in the chuck.
n
Fasten the chuck by hand.
n
Fasten the chuck firmly by inserting the
chuck key in one of the holes in the side
of the chuck and turning it clockwise.
n
In order to remove a drill, proceed in
reverse order.
Before inserting or removing
a drill, always pull the plug
Mounting the side grip
n
Loosen the knob on the side grip (5).
n
Slide the side grip over the chuck on the
machine.
n
Turn the side grip in the required position
and fasten the knob firmly.
Mounting the depth stop
The depth stop is used to limit the maximum
drilling depth.
n
Loosen the knob on the side grip (5).
n
Insert the depth stop (6) in its intended
hole in the side grip.
n
Set the depth stop to the required drilling depth.
n
Fasten knob firmly.
GB HAMMER DRILL
from the wall socket.
Selecting the operating mode
Select the required operating mode before
use (drilling or hammer drilling).
n
For drilling in wood, metal, plastics and
soft stone, slide the switch (3) to the left.
n
For drilling in concrete or hard stone,
slide the switch (3) to the right.
Always wait until the motor
has come to a complete
standstill before changing
Switching on and off
n
To switch the machine on, press the
on/off switch (1).
n
To switch off the machine, release the
on/off switch (1).
n
To switch the machine to continuous
mode, keep the on/off switch (1) pressed
and at the same time press the lock-on
button (2). Subsequently release the on/
off switch.
n
To switch off continuous mode, you press
the on/off switch (1) again.
TECHNICAL DATA
Mains voltage V
Mains frequency Hz
Power input W
Speed (no load) min-1
Drilling capacity in
steel mm
wood mm
concrete mm
Chuck mm
Weight kg
Level of sound pressure measured
according to EN 60745-2:
LpA (sound pressure) dB(A)
LWA (acoustic power) dB(A)
Take appropriate measures
for the protection of hearing.
the operating mode.
230
50
500
0-2,800
6
20
10
13
1.9
87.6
98.6
Publicité
Table des Matières
