Adjust The Door Lock; Adjust The Insulating Cord; Adjust The Door Hinge - Rohde KE 55 LN Mode D'emploi

Enjoy your results

7.2. Adjust the door lock

Frontloaders KE 55 L and KE 70 L series
The door lock can be adjusted in order to guarantee the best possible sealing of the
kiln door.
Loosen the first counter nut and turn the Allen screw half to full turn. Now counter the
screw. Check that the door fits closely and evenly against the kiln (figure 18).
Frontloaders KE-L (100 – 250), KE-N and KE-S series
Loosen the first counter nut and turn the Allen screw half to full turn. Now counter the
screw. Proceed in the same manner with the second door lock. Check that the door
fits closely and evenly against the kiln (figure 19).
7.3. Adjust the insulating cord – Frontloaders KE-L (100 - 250), KE-N and KE-S
series
We recommend that the insulating cord of the kiln door is adjusted every 5 to 6 months.
This provides an even sealing and insulation of the kiln door. Take a clean piece of wood,
place it on the outer edge of the door frame and carefully pull it towards the insulating
cord.
7.4. Adjust the door hinge – Frontloaders KE-L (100 - 250), KE-N and KE-S series
If necessary you can also adjust the door hinge. Make sure that both door hinges are
closed. Loosen the Allen screw of the door hinge and turn it half, max. full turn. Press
the kiln door flat against the kiln body and tighten the screw (figure 21).
28
Page of 80
figure 18
figure 19
figure 20
figure 21
Status: 01 / 2016