Operation Steps; Operation Tips - chaft PU02 Notice D'utilisation

Operation steps

Connect the air tube into inflator, plug the other end to tire valve core
1. When power is off, quickly press the power switch button (C)for three
times within 1.5 seconds, the pump starts to stand by, the screen lights up.
Press UNIT button (B) choose the needed unit, then long-press presetting
button (D)or (E) till the number on screen starts flashing, then press (D) or
(E) to adjust the target pressure. After the pressure gets to the target, press
power switch button (C) to confirm. Or after 15 seconds without any ope-
ration it will be confirmed automatically. When pressure is set, the number
on screen stops pressure flashing.
2. After pressure is set, press power switch button (C), the pump starts
inflating. The pump will stop inflating automatically when the pressure
reachs the target. During inflating, press button(C), the pump will stop. In
the situation of insufficient battery power during the inflating, the pump
will automatically stop. If the pump works continuously for about 5 mi-
nutes, no matter the pressure reaches to the target or not, the pump will
stop forcefully, to avoid damaging the motor and cylinder by overheating.
Then you must have it rest for cooling.
3. Long pressure power switch button (C) for 3 seconds, the pump will
turn off. Or after 3 minutes without any operation, the pump will turn off
automatically.
4. In any time, press light switch button (F), the LED light is on. Press again,
the LED light is off. Whether the pump power is on or not doesn't affect
the LED light using.
5. When the power of the battery in the pump is used up, the pump can't
start inflating, and the LED light gives out darker light or even cannot be
lightened. When this happens, please charge the pump timely.
6. When charging or inflating with car charger, please keep the car engine
on.
7. Charge current limit of the pump is 0.5A. Charging time is 1.5-2 hours.
If not being used for a long time, the pump should be charged at least
once in 3 months, to avoid battery damage caused by power insufficiency.

Operation tips

1. The tire pressure is based on the recommendation of the pressure mar-
ked on the tire.
2. To keep the inflator's long lifetime, please have it rest for 10 minutes in
every 5 minutes working time.
3. Charge the inflator in every 3 months.
4. Make sure the power is enough before using the inflator, and if use car
charger into the cigarette lighter, do not stop the car engine when it in-
flating.
5. During and right after the inflating, the pipe can be very hot. To avoid
being injured, please do not touch the pipe immediately.
4