Install The Shelves - Gladiator Garageworks GAGR0066LG0 Instructions D'assemblage

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Install the Shelves

IMPORTANT:
For storage flexibility, you may choose to install just 2 shelves
allowing room to store larger items underneath.
If you are using only 2 shelves, one rail must be attached to
the bottom holes at the rear of the frame for support as
shown.
1. Place 3 shelf supports across the front and back rails. Place
one shelf support across the middle and one shelf support
across each end with the notches facing inward.
1
2
1. Shelf supports
2. Notch
2. Place the plywood shelf on the shelf supports, fitting it into
the groove of the rails.
3. Repeat this process for the other two shelves.
To Remove the Shelves
1. Lift the plywood shelf off of the rack.
2. Remove the 3 shelf supports.
3. Using a flat-blade screwdriver, pull and hold the rail locking
tab out toward you.
4. Using a rubber mallet, pound up on the bottom of the rail to
release the rail from the frame.
5

Publicité

Table des Matières
loading

Table des Matières