Electric Connection - Smeg Portofino KPF12BL Mode D'emploi

L2
L1
Fig. 5
Fig. 6
L
Z
Z
Fig. 7
EN
FILTER version:
Leave the motor inlet free. Install the active carbon filters as
shown on page 8.
If the hood is not supplied with an active carbon filter you
must buy it separately at your nearest authorised Smeg
dealer.
For some models there is a standard set of fittings (fig.6) to
be fixed to the wall by expansion plugs at a suitable height
in order to channel the airflow in correspondence with the
flue slits. Insert laterally the extensions R2 on the fitting
R1. Connect the fitting R1 at the outlet of the hood body by
means of a tube of diameter D.150mm.
• FLUE ASSEMBLY (fig. 7):
Position the one-piece or two-piece (K) flue bracket to
the required top limit.
Mark the two holes on the wall to fix the bracket. Drill
and fix the bracket with the supplied expansion plugs.
Carefully position the flue unit on the hood. Fix the lower
flue to the hood by means of the screws Z. Carefully
extend the top flue to the upper limit.
L
Secure the top flue to the flue bracket K using the screws
L.
•

ELECTRIC CONNECTION

K
• We recommend that electric connections are carried
out by a professional installer.
In the case of a direct electric connection to the mains,
between the appliance and the mains, place a bipolar
Z
switch with a minimum opening of 3mm between
contacts, sized to the load and compliant with the
current regulations.
4