Connecting The Converter - Dometic GROUP Waeco PerfectCharge DC08 Instructions De Montage Et De Service

PerfectCharge/PerfectPower
 The air intake on the underside or the air outlet on the back of the device
must remain clear.
 For ambient temperatures higher than 40 °C (such as in engine or heating
compartments, or direct sunlight), the heat from the device under load can
lead to the automatic shut-down.
 The installation surface must be level and sufficiently sturdy.
A
NOTICE!
Before drilling any holes, ensure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
6.2 Mounting the converter
➤ Hold the converter against the installation location and mark the fastening
points (fig. 3 A, page 3).
➤ Fasten the converter using your chosen method (fig. 3 B, page 3).
7

Connecting the converter

7.1 Connecting the input battery
!
WARNING!
Do not reverse the polarity. Reverse polarity of the battery con-
nections can cause injury and irreversably damage the device.
A
NOTICE!
Tighten the nuts or bolts to a torque of 12 – 13 Nm. Loose con-
nections may cause overheating.
➤ Set the main switch (fig. 1 6, page 3) to "0".
➤ Lay the positive cable (red) (fig. 1 7, page 3) from the converter to
positive terminal of the battery and connect it.
➤ Lay the negative cable (black) (fig. 1 7, page 3) from the converter to
negative terminal of the battery and connect it.
EN
Connecting the converter
31