Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
It is important to fully assemble
your solar panel kit before use.
Follow these instructions for assembly.
When unpacking, make sure that the
product is intact and undamaged.
If any parts are missing or broken, please
call 1-800-621-5485.
Remove all cord wraps and uncoil the
cables prior to using the solar panels.
Option 1: Tilt Mounting
Insert the threaded side of each mounting
pole into the bolts on the back side of the
solar panel (location is circled below). Next,
place the solar panel on a flat surface, facing
the sun. Repeat with remaining solar panels.
Mounting
poles
Option 2: Flat Mounting
Tools needed:
1/8" flat head screwdriver
Small Phillips Head screwdriver
Mounting brackets and screws
A (4)
SIDE 1
SIDE 2
1. Remove one headless screw with the 1/8"
flat head screwdriver.
ASSEMBLY AND MOUNTING INSTRUCTIONS
Mounted
solar panel
B (8)
2. Align SIDE 2 of bracket C with the opening.
Align on an angle, as shown, so the other
headless screw is visible. Insert screw B.
3. Remove the other headless screw and line
up the bracket over the opening.
4. Insert screw B and tighten securely.
Repeat with remaining brackets and screws.
5. Turn solar panel over and lay on a flat
surface. Insert screw A into bracket C,
SIDE 1. The mounted solar panel should
look like this:
NOTE: Mounting screws (A) are for
installation on wood and other pliable
surfaces. To mount on brick or concrete,
use appropriate screws (not included).
C (4)
• 4 •
Publicité
Table des Matières
