Trouble Shouting - Renson 970180 Manuel D'installation, De Mise En Service Et D'entretien

PROBLEME
Pump does not
Dispense Grease
Very Thick Grease mainly in cold weather
Grease leaks from top
of the pump head
1. Pump should be operated by trained personnel only
2. Always wear Safety Goggles when using the pump
3. Always use Gloves when using the pump
4. Do not point the discharge end towards yourself or anyone as there is potential hazard for
injection into skin / eyes
5. Never allow any part of the body to come in contact with the operating fluid
6. Before operating the pump, check hose for signs of wear, leaks or loose connections. If hose
is weak, worn or damaged, replace the hose immediately
7. Incase of an accident, immediately seek emergency medical attention. Do not try to treat
the injury yourself
8. Use only genuine factory parts for repair
9. Do not smoke when using / near the pump
10. Do not use the pump near a source of spark / open flames etc.

Trouble shouting

CAUSES
Air Pockets / Trapped Air in Grease
Follower plate got stuck
Contaminants causing blockage
Worn Piston Seal
CAUTIONS
NOTES
Révision n°01
REMEDE
Follow Step 11 above
Open the Drum Cover. Resettle the
Follower Plate & follow steps 8 to 11 above
Warm the Grease Bucket a little
Dis-assemble the pump to remove the blockage
Replace the seal. This is a commonly
wearing part and available as a spare part
9