Hama Aluminium Mode D'emploi page 6

• Low battery charge can impair the
connection. Fully charge the battery
if necessary.
• Only one Bluetooth device can be
connected at a time. If there is an
active connection to another
• device, deactivate this connection
and try again.
6.2. Remote release function
• Once you have established the Bluetooth
connection, open the camera function
on your terminal device and select the
desired camera (front or rear camera),
if applicable.
• Mount the smartphone in the bracket (7)
and ensure that it is secure.
• Extend the Selfie "Aluminium" Bluetooth
telescopic pole to the desired length.
• Press the release button (4) to trigger
the selected function (selfie, photo, video).
6.3 LED light function
The Selfie Aluminium is equipped with an
integrated LED light function, which can be
used to light up a handbag, for example.
Press the button once in order to activate
the LED light. If you press the button again,
the LED light will start flashing. Pressing it a
third time ends the LED light function.
7. Care and Maintenance
Only clean this product with a slightly damp,
lint-free cloth and do not use aggressive
cleaning agents. Make sure that water does
not get into the product.
8. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability
and provides no warranty for damage
resulting from improper installation/mounting,
improper use of the product or from failure
to observe the operating instructions and/
or safety notes.
9. Service und Support
Please contact Hama Product Consulting if
you have any questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found
here:
www.hama.com
5