Witti NOTTI Manuel D'utilisation page 4

FCC and CE manual
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Due to the used enclosure material, the GSM mobile phone shall only be connected to a USB
Interface of version 2.0 or higher. The connection to so called power USB is prohibited.
Do not use the mobile phone in the environment at too high or too low temperature,
never expose the mobile phone under strong sunshine or too wet environment.
The suitable temperature for the phone and accessories is 0℃-40℃.
CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES
ACCORDING TO THE INSTRUCTIONS
Regulatory Conformance
Hereby, Corporation declares that this device is in compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC.
For the declaration of conformity, visit the Web site www.wittidesign.com/certification.
Notice: Observe the national local regulations in the location where the device is to be used. This device may be
restricted for use in some or all member states of the European Union (EU)
Limited Warranty 1 year. http://www.wittidesign.com/warranty
R 204-5E0002 IP20
The WITTI logo and NOTTI are trademarks of D&S Creation Limited. All other trademarks are properties of their respective owners. And any use of such marks by WITTI is under license.
Assembled in China www.wittidesign.com ©2015 D&S Creation Ltd. All Rights Reserved
Page: 3/3