König Electronic CMP-MOBDOCK40 Mode D'emploi page 3

Assembly
Insert the hard drive
• Steps 1 & 2: The docking supports 2.5" or 3.5" SATA HDD. Directly plug the hard disk into the SATA
connector, as shown below in photos 1 and 2
• Step 3 & 4: You can easily hot-swap the HDD by directly pulling it out of the docking station, as shown
below in photos 3 and 4
Starting Using CMP-MOBDOCK40
After installing the drive into the docking station, attach the power adapter and turn on the power switch to
start using the external drive. The CMP-MOBDOCK40 supports driverless installation in Windows® XP, Vista
and 7; just plug and play.
Note: USB 3.0 standard is compliant with Windows® XP, Vista, 7; further compatibility of other OS or system
may be updated without prior notice by their manufacturers.
Formatting the Hard Disk
The entire drive has to be formatted before use. If using a drive which has been formatted before, there is no
need to format again. Follow the steps below:
1. Right click My Computer and select Manage
2. Management window will show up. Click Disk Management under Storage
3. Computer Management window will list all the disks in the computer
4. Right click on partition disk and click New Partition
5. New Partition Wizard will show up, click Next
6. Select the Primary partition or Extended partition that you want, click Next
7. Fill in the numbers of capacity that you prefer to partition, click Next
Note: Format tool was provided by Windows®, the maximum capacity of FAT32 is 32 GB.
8. Select Assign the following drive letter, click Next
9. Select Format this partition with the following settings and choose the File system that you want
10. You can enter the Volume label that you want. Choose perform a quick format, click Next
11. You can see a new partition in the Disk Management
12. The new disk can be seen on the computer
3