Table des Matières
Publicité
SAFETY NOTES
We strongly recommend wearing protective gloves during the assembly.
Do not attempt to assemble the wall-mounted gazebo in windy or wet weather condi-
tions.
Make sure the aluminium sections never touch any overhead electrical wires.
Always wear safety shoes and goggles when working with extruded aluminium.
Remove the plastic packaging and keep it out of reach of small children.
The wall-mounted gazebo must be set up on a flat,
even surface.
Do not lean on or push the gazebo during the assembly procedure.
Keep children away from the assembly area.
Do not set up the wall-mounted gazebo in areas that are exposed to strong winds.
Do not attempt to assemble the gazebo if you are feeling tired, are on medication,
have consumed alcohol or if you are prone to spells of dizziness.
When using a stepladder or electrical devices, always follow the manufacturer's safety
instructions.
Never store any items such as recently used grills, torches etc. in the gazebo.
Make sure that no underground pipes, tubes or cables run beneath the areas in which
you wish to sink the mounting pins.
GENERAL ADVICE
The assembly covers several steps.
Allow at least 240 minutes for the assembly.
Choose a sunny spot with no overhanging tree branches.
If you wish to fasten the wall-mounted gazebo directly onto a concrete base, use the
pre-drilled holes in the metal base that is included in the delivery.
Check each of the gazebo's parts and components and place them within easy reach.
Place small items (screws etc.) in a bowl to prevent losing them.
Keep the roof free of snow and foliage.
CARE & MAINTENANCE
If your wall-mounted gazebo needs cleaning, use a mild detergent and rinse with
clear cold water.
NEVER use acetone, abrasive cleaners or other special detergents to clean the
transparent panels.
- 107 -
TOOLS & REQUIRED EQUIPMENT
Protective equipment:
1.Hard hat
2.Gloves
3.Long-sleeve cotton overall
4.First aid kit
5.Safety goggles
Measuring equipment (metric):
1.Tape measure
2.Joiner angle
3. Spirit level
Mounting tools:
1.
Stepladder (1.5 metres)
2.
10 mm spanner (ideally, use a ratchet wrench)
3.
14 mm spanner (for fastening expansion screws)
4.
5 mm hexagon wrench
5.
Electric screwdriver & 5 mm hexagon wrench
(suggested)
6.
Mallet
7.
Pen for marking
8.
Silicone caulk
9.
Impact chisels
(8 mm and 10 mm)
10. Knife
11. Phillips
screw driver
Silicone
caulk
Publicité
Table des Matières
