LEXIBOOK DJ050 Série Mode D'emploi page 30

2. Your batteries may be low. Place new batteries or fully recharged batteries
in your camera.
3. Check that you have installed the batteries correctly.
Q: Why does nothing happen when I press the SHUTTER button?
A:
1. The camera may be still be doing a previous action such as recharging
the flash, saving, copying or erasing a photo. Wait a few seconds and try
again.
2. The camera's built-in or SD card memory may be full. If this is the case,
you need to delete photos from you camera. Make sure you transfer any
photos you want to keep to your computer first.
3. The timer may be counting down wait a few seconds.
Q: Why are my pictures unclear?
A:
1. The lens may be dirty. Gently blow any loose dust from the lens. Then
breathe gently on the lens and wipe it with a soft, clean cloth that has no
chemicals on it.
2. Make sure you hold the camera steady until after the red LED light has
gone out.
3. You may be too close to your subject. Try moving further away.
Q: Why are my pictures too dark?
A:
1. The flash may be turned off. See the 'Taking Pictures' section for how to
set the flash.
2. The flash may need replacing. Take the camera to your nearest dealer for
servicing.
3. You may need to move closer to your subject or your subject may need to
move to a lighter area.
4. Your exposure, ISO, white balance or scene settings may be incorrect for
your environment. See the 'Settings Menu' section for how to change these
settings.
Q: Why are my pictures too light?
A:
1. You may not need the flash function. See the 'Taking Pictures' section for
how to change the flash setting.
2. Your exposure, ISO, white balance or scene settings may be incorrect for
your environment. See the 'Settings Menu' section for how to change these
settings.
Q: What do I do when a memory card error message appears?
A:
Check the memory card instruction manual to make sure it is compatible and
has been correctly formatted for your camera.
30