Assembly; Operation - Husqvarna TF230 Manuel D'utilisation

Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.
To assemble the tine blades (TF230)
• Refer to the illustration for an overview of the bolts,
screws, nuts and washers that is necessary to
assemble the tine blades. (Fig. 16)
• Obey the instructions in the illustrations below.
Note: The illustrations only show the assembly of the
tine blades on the right side. The same instructions
are applicable on the left side. Make sure that the
sharp edges point in the same direction on the right
and left tine blades.
(Fig. (Fig. (Fig.
17) 18) 19)
To assemble the tine blades (TF338)
• Refer to the illustration for an overview of the bolts,
screws, nuts and washers that is necessary to
assemble the tine blades. (Fig. 23)
• Obey the instructions in the illustrations below.
Note: The illustrations only show the assembly of the
tine blades on the right side. The same instructions
are applicable on the left side. Make sure that the
sharp edges point in the same direction on the right
and left tine blades.
(Fig. (Fig. (Fig.
24) 25) 26)
To assemble the product
1. Install the connection joint.
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To do before you operate the product
• Do an inspection of the work area. Remove all loose
objects that can eject from the product and cause
serious injury to the operator or others. Such items
include stones, glass or steel wire.
1419 - 003 - 09.07.2020

Assembly

(Fig. (Fig. (Fig.
20) 21) 22)
(Fig. (Fig. (Fig.
27) 28) 29)

Operation

a) For TF230: (Fig. 30)
b) For TF338: (Fig. 31)
2. For TF230, install the support wheel. (Fig. 32)
3. Install the drag bar.
a) For TF230: (Fig. 33)
b) For TF338: (Fig. 34)
4. Install the handlebar. (Fig. 35)
5. Adjust the height of the handle and tighten the
knobs. (Fig. 36)
6. Turn the clutch control to the correct side. Attach the
bolt. (Fig. 37)
7. Install the cable cover.
a) Install the cables correctly.
b) Install the rubber holder. (Fig. 38)
c) Install the cable cover and tighten the screw.
(Fig. 39)
8. Install the tine cover (TF230).
CAUTION: Install the 4 bolts and nuts
before your tighten them fully.
a) (Fig. 40)
b) (Fig. 41)
c) (Fig. 42)
9. Install the tine cover (TF338):
a) (Fig. 43)
b) (Fig. 44)
c) (Fig. 45)
10. Install the gear lever. (Fig. 46)
11. After assembly, tighten all bolts and nuts again.
CAUTION: Do not disassemble the product.
Speak to an approved servicing dealer for
that task.
• Do a check of the engine oil level and fill engine oil if
it is necessary.
• Do a check of the oil level of the gearbox and fill oil if
it is necessary.
• Do a check of the fuel level and fill fuel if it is
necessary.
• Do an overhaul of the product.
a) Replace worn or damaged parts.
b) Do a check for fuel leaks.
c) Make sure that all guards and covers are
installed correctly.
d) Do a check of all nuts and screws.
11