Renusol FS10-EW Notice D'installation page 3

!
GB | General Guidelines
Mounting system for installing framed
PV panels with thicknesses of between
30 and 50 mm on pitched roofs with
the following characteristics:
• Trapezoidal metal sheet
• Steel thickness 0.4 - 1.25 mm
• Aluminum thickness 0.5 - 1.50
mm
• Width of raised beads 12 mm
• Roof pitch 0° - 20°
The installation on sandwich roofs re-
quires the manufacturer's approval.
Be sure to observe the relevant regula-
tions, latest technology standards and
current health and safety guidelines
during installation and, in particular,
while working on the roof.
Testing/certification:
Technical approval:
• MS+ (R420402/R420403)
TÜV ID: 1111212485
• MS+ (R420405)
ETN 010T1606
• MS+P (R420422)
TÜV ID: 1111212485
• MS+P (R420421)
MCS012 IK0197/02
TÜV ID: 1111212485
• FS10-S, FS18-S, FS10-EW
TÜV ID: 1111212485
Modules are always to be mounted in
landscape.
When mounted by the FS10-S/FS18-S
, modules are mounted in the corner
of the long sides. It must be checked,
whether the value specified by the
module manufacturer clamping range
is maintained.
Drain holes in PV module frame must
be kept clear and may not be obscured
by the mounting system.
The roof area must be free of snow, ice
and dirt during installation.
Be sure to observe the relevant regula-
tions, latest technology standards and
current health and safety guidelines
during installation.
A suitable subsurface that can absorb
any forces that may occur (weight,
!
The structural stability of the PV system
must be verified before installation. The
building construction, roofing and in-
sulation must withstand the additional
loads safely.
wind and snow loads) is always a
prerequisite for use in accordance with
regulations. Water drainage on the
flat roof and its direction must also be
taken into consideration.
Windreport
The pressure and suction coefficients
are calculated on the basis of wind
tunnel tests and are available from
Renusol GmbH on request.
Applicable Documents
"General installation, maintenance
and assembly instructions"
"Safety Instructions for Installation
Instructions"
"Warranty and Disclaimer."
These documents are available at
www.renusol.com
Warranty
The Renusol warranty only applies
if an original FS complete system is
used and the warranty terms and con-
ditions are met. For implied defects
liability/warranty please refer to the
Renusol General Terms and Condi-
tions.
www.renusol.com
Renusol FS-Systems on trapezoidal sheets | 03/2020 | 3/28