Livington Fitmix Mode D'emploi page 9

section titled Cleaning.
• Dry off the blender and all of its
parts before fitting components and
before connecting the unit to the
power supply.
• Always operate the appliance on a
stable, flat, clean and dry surface.
• Do not glue foreign objects onto the
appliance.
• Keep hands and utensils, other than
the stirrer, out of the pitcher when it
is on the power unit.
• Never use attachments that are not
intended for this blender.
• It is only possible to turn on the ap-
pliance when the plug is connected
to an electric socket.
• Compare the connection informa-
tion (voltage and frequency) on the
rating plate with that of your electri-
cal network.
The only way to disconnect the
appliance from the power supply is
to pull the plug from the socket.
• Do not accidentally trip over the
power cord while the appliance is in
operation.
• Set up the appliance so that the
power plug is always accessible.
• Before removing the pitcher or Mi-
ni-Mixer from the power unit, wait
until the blades have completely
stopped.
• Only operate the blender with its lid
in place.
• Use the plunger only when the lid is
on the blender jug. Do not put too
much pressure on the plunger, as it
600Watt Fitmix Manual - M7435+M7438+M7439 _Bedienungsanleitung-fitmix_A_150120_PRINT.indd 9
could then touch the blade.
WARNING
• Packing material is not a toy for
children, it is a suffocation hazard!
• When cleaning the cutter assembly,
one has to be especially careful to
avoid injury because the blades are
extremely sharp.
• Touching live lines and parts under
voltage poses a lethal risk of elec-
trocution.
• Avoid damaging the power cord.
Do not crush it, twist it, or pull it
over sharp edges. Keep it away
from hot surfaces or open fire.
• Never use the appliance when the
unit or the power cord is damaged.
• Under no circumstances must the
appliance be opened. The manu-
facturer assumes no liability for
damages due to improper use.
• Do not use any tools or objects
inside the appliance. Metal objects
can generate an electrical short or
cause an electric shock.
OPERATION
1. Remove all packaging material and discard it in accordance
with local laws and regulations.
2. Clean the blender and all components before using it for the
first time. (See Cleaning)
3. If you want to use the tap(E), then unscrew the screw top(S)
and then screw the tap(E) to the blender(D).
Tip: you can operate the blender using the screw top(S) or tap
(E).
4. Place the pitcher (D) on the power unit (G) and twist until
the pitcher locks into place. Make sure that the spout lever
(F) is in the OFF-position (H).
5. Place the ingredients into the pitcher (D). We recommend
adding solid ingredients first and adding liquids second. You
can use fruits, fresh yoghurt, milk, juice, vegetables, etc.
You can also add ice or frozen ingredients to the pitcher, for
example frozen fruit, frozen yoghurt or ice cream. Tip: When
using hot or frothy liquids (e.g., milk) or frozen ingredients,
the pitcher should only be filled up to the 1000 ml mark.
6. Place the lid (C) on the blender jug (D) before plug-
9
18.02.15 11:24