emerio WH-125971 Mode D'emploi page 7

WH-125971
PARTS DESCRIPTION
1. Air outlet (with a cover)
2. Air inlet
3. Digital display and indicator lights (see the table below)
4. Power switch
5. One-start button
6. Hanging hole
7. Remote control
Heating indicator light: low heating --- one light
on; No heating (Only the fan is working.) --- no light on.
Temperature setting indicator light. When you set the temperature, this light will be on. When
you select the open window detection, this light will be flickering.
Week timer indicator light. When you have set the week timer, this light will be on (the current
time belongs to the set time range) or flash (the current time is not in the set time range).
Swing indicator light. When you select the swing function, this light will be on. If you turn off
the swing function, this light will be off.
Working indicator light. It indicates the appliance is working. After flashing for 10 minutes and
there is no operation, this light will turn off. If you press any button on the control panel, this
light will flash again.
Remote control
This unit has a remote control. One piece of CR2025 battery will be provided with the remote control. Before
starting to use the remote control, remove the plastic protection from the battery. If you want to change the
battery, please refer to the instruction behind the remote control. If it is not in use for a long time, please take
the battery out of the remote control. Keep button cell batteries out of reach of small children.
The functions of this appliance are mainly controlled by the remote control, whose buttons are explained in
below table.
Function
Button
ON/Standby
Explanation
Press it, the appliance is on. Press it again, the appliance enters into
standby (If the appliance has worked before with the heating function, its
fan keeps working for 30 seconds with a countdown on the display.). In
standby, the room temperature is still displayed.
- 6 -
on; high heating --- two lights
EN