Dmx Connection; Set Up; Control Panel; Automode - Evolite EVO SPOT 90 Mode D'emploi

o DMX 512 Connection
The wires must not come into contact with each other, otherwise the fixture will not work at all or
properly. Please note the starting address depends upon which controller is being used. Only use a
DMX cable and 3-pin XLR-plugs and connectors in order to connect the controller with the fixture or
one fixture to another
Connection with the mains.
The earth has to be connected. The device must only be connected with an electric installation
carried out in compliance with IEC standards.
 Set up

Control panel

o
The control board offer several features:you can simple set the starting address, run the pre-
programmed program or make a reset.
Address
Mode
Display
Test Mode
Options
Infos
Back
DMXMode √
Address

AutoMode

Mode
Sound Mode
Display
Master/Slave.
Test Mode
Options
Infos
Back
EVO SPOT 90 Manual Ver. 1.00
001
YES / NO
14
Page