Hama 173898 Mode D'emploi page 4

3.1 Attaching the holder (B)
• Carefully push the ventilation grille clamp onto the open panels of the ventilation grille
until it locks into place
Note
Before setting a device in the holder, check that the panels are sturdy enough to bear the
weight. We recommend against using this model for terminal devices heavier than 300 g.
• To remove the holder, carefully pull it out of the ventilation grille.
3.2 Adhesive pad (magnetic)
Note – Adhesive surface
• Ensure that the mounting surface to which the adhesive pad is to attach (such as the
back of a mobile phone, GPS navigation system, etc.) is free of dust and grease. Use a
suitable cleaning agent from a specialised dealer to clean the surface.
• Various environmental factors such as ambient humidity, sunlight or cold can impair the
durability of the adhesive pad.
• We cannot guarantee that residue will not be left on the mounting surface after the
adhesive pad is removed.
• Remove the protective foil from the adhesive side of the magnetic pad, and press the pad
onto the adherend surface (for example, rear of mobile phone) for a few seconds.
• The rectangular magnetic pad can simply be inserted between the protective cover and the
back of the mobile phone.
4. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no warranty for damage resulting
from improper installation/mounting, improper use of the product or from failure to observe
the operating instructions and/or safety notes.
5. Service and Support
Please contact Hama Product Consulting if you have any questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
3