Applications; Safety Notes; Setting The Spotlight Into Operation - Leuchtkraft ODC-100/CTW Mode D'emploi

DMX LED Spotlight
Operation of the spotlight is easy for users with
basic knowledge in DMX control . However, please
read the instructions carefully prior to operation
and keep them for later reference . On page 2,
you will find the spotlights ODC- / CTW and PARC-
100 / CTW together with the menu structure .

1 Applications

This LED spotlight is used for illumination, e . g .
on stage, in discotheques and function rooms .
The light source is a powerful COB LED (COB =
chip-on-board technology): Many individual LED
chips are densely packed on a PCB to provide a
uniform light distribution . Half of the LED chips
are designed for warm white, and half of the LED
chips are designed for cool white . Change the
brightness ratio between cool white and warm
white to set the colour temperature of the light
beam to a value between 2700 K and 5600 K .
The spotlight is designed for control via a
DMX light controller (4 DMX control channels),
but it can also be operated independently with-
out a controller . The ODC-100 / CTW is weather-
proof (IP 66) and therefore also suited for outdoor
applications .

2 Safety Notes

The spotlight corresponds to all relevant directives
of the EU and is therefore marked with
WARNING The spotlight uses dangerous
mains voltage . Leave servicing to
skilled personnel; inexpert han-
dling may result in electric shock .
•
The spotlight PARC-100/CTW is suitable for
indoor use only . Protect it against dripping
water and splash water, high air humidity and
heat (admissible ambient temperature range:
0 – 40 °C) .
The spotlight ODC-100/CTW is suitable for out-
door applications (admissible ambient temper-
ature range: −20 to +40 °C) .
•
Immediately disconnect the mains plug from
the socket
1 . if the spotlight or the mains cable is visibly
damaged,
2 . if a defect might have occurred after the
spotlight was dropped or suffered a similar
accident,
8
3 . if malfunctions occur .
In any case the spotlight must be repaired by
skilled personnel .
•
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug .
•
For ODC-100 / CTW only: A damaged mains
cable must be replaced by skilled personnel only .
•
No guarantee claims for the spotlight and no
liability for any resulting personal damage or
material damage will be accepted if the spot-
light is used for other purposes than originally
intended, if it is not safely installed or not cor-
rectly connected or operated, or if it is not re-
paired in an expert way .
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not harmful
to the environment .
3 Setting the Spotlight
into Operation
3.1 Installation
•
Always position the spotlight in such a way
to ensure sufficient air circulation during
operation . Never cover the cooling fins of the
housing .
•
Always keep a minimum distance of 50 cm to
.
the illuminated object .
WARNING When the spotlight is installed at
safety rope through the eyebolt on the rear of
the spotlight and fasten it in such a way that
the maximum falling distance of the spotlight
will not exceed 20 cm .
1 . Install the spotlight via its mounting brackets,
e . g . with a stable mounting screw or a support
for lighting units (C hook) on a cross bar .
To align the spotlight, release the two lock-
ing screws of the mounting brackets . Adjust
the desired inclination of the spotlight and
fasten the screws .
2 . Alternatively, set up the spotlight on its own:
Fold out the mounting brackets underneath
the spotlight and use them as a stand . Then
fasten the locking screws .
a place where people may walk or
sit under it, additionally secure it,
e . g . via a safety rope . Guide the