Festo 8049382 Notice D'utilisation page 21


Maximum permissible current loads for cables and devices must not be exceeded.
– Always compare the current ratings of the device, the cable, and the fuse.
– In the event that these are not the same, use a separate upstream fuse in order to
provide appropriate overcurrent protection.

Use only connecting cables with safety plugs for electrical connections.

When laying connecting cables, make sure they are not kinked or pinched.

Do not lay cables over hot surfaces.
– Hot surfaces are identified with a corresponding warning symbol.

Make sure that connecting cables are not subjected to continuous tensile loads.

When replacing fuses, use specified fuses only with the correct current ratings and tripping
characteristics.

The device is not equipped with an integrated fuse unless otherwise specified in the technical data.

Always pull on the plug when disconnecting connecting cables; never pull the cable.

Hazard-free operation of the device is no longer possible in the case of:
– Visible damage
– Malfunction
– Incorrect storage
– Incorrect transport
– Switch off the power supply immediately.
– Protect the device against inadvertent restart.
© Festo Didactic 8049630
21