Yalp Solar YA 3200 Instructions D'installation page 36

WARNING When using heavy equipment
follow the safety instructions provided by the
manufacturer.
CAUTION The person(s) transporting the product
should wear the required protection and clothing.
• Before transporting check the box and pallet
for any damage or loose parts
• When using (heavy) equipment make sure the
person is certified when required to use the
equipment
• Always transport the product upright
• Always use the supplied pallet and transport
materials
• Extra equipment may be necessary to safely
transport the product
• Make sure the used equipment can handle the
weight and size of transporting the product
• Transport the product as close as possible
to the eventual place of installation before
unpacking the product
A.2 Dimensions of the installed Solar pole
A.3 Overview of products and additional material
EN EN
CAUTION The person unpacking the product
should wear the required protection and clothing.
NL
CAUTION Do not unpack the product before
transporting it to the eventual place of installation
DE
to prevent damages.
FR
• Use a forklift to load and unload the pallets
• Use a cross slot screwdriver (not included) to
open the wooden crate
• Unpack the product in a dry environment
• While unpacking the product check the product
for any damages or missing parts
• Check cables for any damages
B. DEEP MOUNT
NOTICE Make sure the necessary preparations
have been made according to chapter A.
B.1 Dig a hole according to the indicated
dimensions. *Determine the depth of the cable
according to local standards.
YA3200-210723
• Please recycle and discard the packaging
material correctly
A.4 Make sure that the distance between the
interactive product and the Solar panel is more
than 1.5 meters (5ft) and no more than 6 meters
(20ft).
A.5 Make sure that there is enough distance
between the anchor plate and a potential object
(e.g. a wall).
A.6 Determine the position of the Solar pole. When
the product is placed in the Northern Hemisphere,
face the Solar panel south, as shown in the image.
Is the product placed in the Southern Hemisphere,
face the Solar panel north.
NOTICE In the image, the placing on the
Northern Hemisphere is shown. Placing the product
in the wrong direction will lead to a suboptimal
power generation.
A.7 Determine from which side the cables will be
connected to the Solar pole.
NOTICE
Make sure the cable slot will not cross
any of the anchor points.
A.8 If needed, prepare the ground:
• Make sure the surface is level in all directions
• Determine ground level (0 level), which is the
reference point for all other dimensions
• Make sure that the Solar pole will be placed
perpendicular to and directly on the prepared
surface
A.9 Choose the installation type suitable for the
surface on which the Solar pole will be installed.
• Deep mount (in existing ground): continue with
part B
• Surface mount (on top of existing surface):
continue with part C
NOTICE The slot can be made in various
directions. Please make sure the cable slot will not
cross any of the anchor points, according to image
A.7.
B.2 Determine the length of the cable protection
tube (conduit) and cut to size with a knife. Place
36