Using The Setup Wizard - Unify Circuit Meeting Room Guide D'installation Rapide

Setting up the Circuit Meeting Room Software
A setup wizard will guide you through the initial configuration process of the Circuit
Meeting Room.
Circuit Meeting Room is configured using web pages ("Dashboard"). You can access
the Dashboard either by:
• Reading the Network IP address from the display and enter it in a web browser on
your computer in the same network:
or by
• Connecting a USB keyboard and mouse to a USB connector
Your browser (and the display) shows the Dashboard landing page. After first login,
the setup wizard will start automatically.
NOTE: The setup requires connection to the network and access to the Internet.
Please check the network configuration before (DHCP available, proxy configuration).

Using the Setup Wizard

1 Login to the Dashboard
Login to the Dashboard using the de-
fault administrator password:
Admin%123
The setup wizard starts.
3 Change password
Change the password for accessing the
Dashboard.
5 Check for update
If no update is available, click OK to fin-
ish the setup wizard.
1 Depending on your available network bandwidth, this may take a few moments.
Registering the Circuit Meeting Room to Circuit
Once the setup completes, the Dashboard displays the Circuit configuration page. Fol-
low the steps described below to register the Circuit Meeting Room to Circuit.
1 Determine Device ID
Read the Device ID from the Circuit
Meeting Room display or the browser
you are using to access the Dashboard
and provide this to your Circuit Domain
Administrator.
3 Enter the registration code
Enter the registration code you received
in the Circuit configuration page of the
Dashboard.
1 The registration code is automatically generated by Circuit once the Circuit Domain Admini-
strator adds your device to your Circuit domain. For more information please visit:
www.circuit.com/unifyportalfaqdetail?articleId=120430.
https://<ip-address>
2 Review EULA
Read and accept the End User License
Agreement (EULA) for the pre-installed
Unify software.
4 Check internet connection
If the Circuit Meeting Room does not
have an internet connection, click Can-
cel while the check is in progress or OK
afterwards to get to the Network configu-
ration page of the Dashboard and edit
the network settings. After submitting
the changes, the setup wizard resumes.
6 Update device
If an update is available, click Install up-
1
date .
2 Get temporary registration
code
The Circuit Domain Administration pro-
vides you with a temporary registration
1
code .
4 Completing configuration
Circuit Meeting Room
displays its idle screen
with the following in-
formation:
• Name of the Circuit
Meeting Room
• IP address of the
Circuit Meeting
Room, in case re-
mote access
Dashboard is need-
ed
• PIN required for activation
• Short instructions on how to use the
Circuit Meeting Room
• Installed version of the Circuit App
1
.
to
5