König Electronic SEC-DVRDCD10 Mode D'emploi page 4

Note: if the indicator does not light up, press the on/off button of the remote control
to turn it on.
2. To record only audio, press the start/stop recording audio button. The red
indicator starts to flash slowly. Press again to stop audio recording.
General
- When no function is activated within 1 minute, the power will automatically shut
down to save battery power.
- The video, photo and audio files are stored in the folder DCIM, 100 MEDIA.
Connect the device to a computer or notebook with the USB cable. Select in the
window "open folder to view files".
- When the battery power is low during use, the current file will be saved before
the device turns off.
- When the device does not power on, then the battery power is probably low and
needs to be charged again before use.
- When the Micro SD card is defective of not inserted, the red indicator will flash
for a few seconds and then automatically turn off.
- Save your data when you connect to a computer otherwise the data will be
over-written when the SD card is full.
- When the switch is set to on and the red indicator is off, then the camera is in
stand-by mode.
- When the device is running out of memory the red indicator will remain on and it
is not possible to record any further.
Time and Alarm Settings of the Digital Clock:
Time set
1. Press and hold the mode button for a few seconds until the hours starts to flash.
Use the + and - button to adjust the hour.
2. Press the mode button again to set the minutes with the + and - button.
3. Press the mode button again to set the year with the + and - button.
4. Press the mode button when ready, the year stops flashing.
5. Press the shift button to return to the time.
6. Press the - button to set 12 or 24 hour system.
Alarm set
1. Press the shift button to enter alarm setting (ALM indication appears in the
display).
2. Press and hold the mode button to set the hour with the + and - button.
3. Press the mode button again to set the minutes with the + and - button.
4. Press the mode button and select with the + and - button for the alarm music
sound.
5. Press the shift button to save the alarm setting.
6. Press the - button to select the following options:
Alarm activated
Activate repeat alarm every 5 minutes up to a maximum of 6 times
4