Troubleshooting; Technical Data; Limited Warranty - GreenWorks Pro PH80B00 Manuel Opérateur

EN
12

TROUBLESHOOTING

Problem
The motor shuts
down whilst work-
ing.
The machine
smokes during op-
eration.
The motor is on,
blades do not
move.
Too much noise
and/or vibration is
experienced while
working.
13

TECHNICAL DATA

Voltage
No load speed
Blade length
Cutting capacity
Weight (without battery
pack)
Battery model
Possible cause Solution
Make sure that
The battery pack is you tighlty instal-
not installed tight- led the battery
ly. pack in the ma-
chine.
The battery pack is Charge the battery
out of power. pack.
The machine has Do not use the ma-
damage. chine and speak to
service center.
1. Immediately
stop the ma-
chine.
The machine has
2. Remove the
damage.
battery.
3. Speak to serv-
ice center.
Do not use the ma-
The machine has
chine and speak to
damage.
service center.
Remove battery
The blades are then clear block-
blocked. age from the
blades.
1. Stop the ma-
chine.
2. Remove the
battery.
The parts are loos-
3. Inspect for
en.
damage.
4. Check and
tighten loose
parts.
Do not use the ma-
The parts have
chine and speak to
damage.
service center.
80V
3000(±10%) SPM
20"
3/4"
9.46 lbs. (4.29 kg)
GBA80200, GBA80250,
GBA80400, GBA80500 and
other BAB series
English
Charger model
14

LIMITED WARRANTY

Greenworks hereby warranties this product, to the original
purchaser with proof of purchase, for a period of four (4)
years against defects in materials, parts or workmanship.
Greenworks, at its own discretion will repair or replace any
and all parts found to be defective, through normal use, free
of charge to the customer. This warranty is valid only for
units which have been used for personal use that have not
been hired or rented for industrial/commercial use, and that
have been maintained in accordance with the instructions in
the owners' manual supplied with the product from new.
ITEMS NOT COVERED BY WARRANTY:
1. Any part that has become inoperative due to misuse,
commercial use, abuse, neglect, accident, improper
maintenance, or alteration; or
2. The unit, if it has not been operated and/or maintained in
accordance with the owner's manual; or
3. Normal wear, except as noted below;
4. Routine maintenance items such as lubricants, blade
sharpening;
5. Normal deterioration of the exterior finish due to use or
exposure.
HELPLINE:
Warranty service is available by calling our toll-free helpline,
at 1-855-345-3934.
TRANSPORTATION CHARGES:
Transportation charges for the movement of any power
equipment unit or attachment are the responsibility of the
purchaser. It is the purchaser's responsibility to pay
transportation charges for any part submitted for replacement
under this warranty unless such return is requested in writing
by Greenworks.
USA address:
Greenworks Tools
P.O. Box 1238
Mooresville, NC 28115
10
GCH8040 and other CAB
series
Canadian address:
Greenworks Tools Canada Inc.
1110 Stellar Drive Unit 102
Newmarket, ON, L3Y 7B7