Hama LP11 Mode D'emploi page 6

5. Operation
Inserting the battery (pic. 1)
• Always use two LR1 batteries.
• To insert or change the batteries, unscrew the device and insert the LR1 batteries
with the correct polarity into the battery compartment.
• Screw the device back together.
Operation
• Press the laser button (B) to activate the built-in laser.
6. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do not use aggressive
cleaning agents.
7. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no warranty for damage
resulting from improper installation/mounting, improper use of the product or from
failure to observe the operating instructions and/or safety notes.
8. Service and Support
Please contact Hama Product Consulting if you have any questions about this product.
Hotline: +49 9091 502-0 (German/English)
Further support information can be found here: www.hama.com
9. Specifications
Operating voltage
Power supply
Maximum output power (laser)
Wavelength
Laser class
10. Recycling Information
Note on environmental protection:
After the implementation of the European Directive 2012/19/EU and
2006/66/EU in the national legal system, the following applies: Electric and
electronic devices as well as batteries must not be disposed of with
household waste. Consumers are obliged by law to return electrical and
electronic devices as well as batteries at the end of their service lives to the
public collecting points set up for this purpose or point of sale. Details to this are
defined by the national law of the respective country. This symbol on the product, the
instruction manual or the package indicates that a product is subject to these
regulations. By recycling, reusing the materials or other forms of utilising old devices/
Batteries, you are making an important contribution to protecting our environment.
4
3 Volt
2 x 1.5V/DC LR1 batteries
< 1mW
540 nm
2