LOTRONIC BST AD600 Manuel D'utilisation page 4

9) AC SOCKET + FUSE
Before to connect the ac cord on this socket, make sure that the available voltage is not higher than stated at the end of this
manual
The ac fuse is integrated on the power connector. It's used to avoid power supply default on speaker. if the ac cord is connected
and power switch push on the position on but speaker doesn't work, please check the fuse. if the fuse is out of order, replace it by
fuse with same size and same value.
10) POWER SUPPLY SELEC
The main power supply is different between country ( in france :220V ). Select the good value with the switch ( 110V or 220V )
DESCRIPTION AD1000
1) POWER SWITCH
Used to switch the power amplifier on or off
2) VOLUME CONTROL CHANNEL A
In stereo mode, this two control is used to adjust volume of the channel A
In bridge mode, only the A volume control adjust the level of the bridge output
3) VOLUME CONTROL CHANNEL B
In stereo mode, this two control is used to adjust volume of the channel B
4) SIG & LIMIT LED
The SIG led give you in information about level of signal.
- If the led is off, that means the level is low
- If the led flashes, that mean the level is good.
- If the led lights on, that mean the level is good but near from it max level
The LIMIT led lights on when the level is too high. in this case, decrease the level
5) MODE SWITCH
This switch is used to choose the operating mode of the power amplifier : stereo or bridge
6) INPUTS
Connect on these sockets ( XLR ) the output of your mixer ( or of the cd player )
7) LINK OUTPUTS
Connect on these sockets ( XLR ) the input of an other power amplifier, an active speaker or a record device
© Copyright LOTRONIC 2014 AD600-AD1000 Page 4