Levelling The Washing Machine; Connecting The Water Supply Hose - Auchan Selecline 600082784 Manuel D'utilisation

4.3 Levelling the washing machine

Warning!
The lock nuts on all four feet must be screwed tightly against the housing.
1. Check if the legs are securely attached to the housing. If not, turn them to their
original positions and tighten the nuts.
2. Loosen the lock nut and turn the foot until it is in close contact with the floor.
3. Adjust the legs and lock them with a spanner, making sure that the machine is
steady.
4.4 Connecting the washing machine

4.4.1 Connecting the water supply hose

Warning!
To prevent leakage or water damage, follow the instructions in this chapter!
Do not bend, crush, modify or sever the water inlet hose.
If the model is equipped with a hot valve, connect it to the hot water tap with
the hot water supply hose. Energy consumption will decrease automatically for
some programs.
Connect the inlet pipe as indicated. There are two ways to connect the inlet pipe:
4.4.1.1 Connection between ordinary tap and inlet hose.
clamp out
Loosen the clamp Tighten the clamp
nut and four bolts
Lower
Raise
slide bushing
Press the slide
bushing and insert
the inlet hose into
nut
the connecting
base
17
Lock nut
foot
Connection
complete