Citadel F Série Instructions D'assemblage page 17

5
Chart
6
You can now spread approximately 10 cm (4") of compacting sand
all around the inside base of the wall in order to protect the liner
from the cutting edges of the bottom wall tracks and the stone dust
(if applicable), or install a prefabricated cove if available.
SAND BASE FINISHING
Level finishing sand one last time. Make sure that any sharp stones,
debris or roots have been removed from the surface. For better pro-
tection, spray sand with water and pack it once more until the base
is nicely even.
7
Before pulling the liner up against the wall, insert a vacuum cleaner
hose down into the pump return hole to approximately 15 cm (6")
from the ground.
PUMP RETURN HOLE
VACUUM CLEANER
GROUND LEVEL
Maintain the hose in place with adhesive tape. Don't forget to block
the skimmer hole with adhesive tape to prevent air from leaking in.
WALL INSTALLATION (continued)
POOL
DIAMETER
3,05 m (10')
3,66 m (12')
4,57 m (15')
5,48 m (18')
6,40 m (21')
7,31 m (24')
8,22 m (27')
9,14 m (30')
10,06 m (33')
SAND BASE FINISHING
VINYL LINER INSTALLATION
INNER WALL
15 cm (6")
ACTUAL LENGTH
OF WALL
9,55 m (31' 4")
11,58 m (38')
14,38 m (47' 2")
17,07 m (56')
20,02 m (65' 8")
22,89 m (75' 1")
25,73 m (84' 5")
28,60 m (93' 10")
31.45 m (103' 2")
10 cm (4")
SAND COVE
(or PREFAB COVE)
Place the unfolded liner in the center of the pool area at right angles
with the skimmer hole. Make sure you wear light, flat-soled shoes
to walk on the sand as the slightest heel mark could be visible once
the pool is filled.
Carefully unfold the liner, bringing the bottom-sidewall seam close
to the wall base. Make sure that the side with the protruding seams
faces downward or that the patterned side faces upward.
30 cm (12")
LINER
WALL
BOTTOM
TRACK