The Controls Of Your Wine Cooler; Setting The Temperature; Function Instruction - Silhouette Select DWC93BLSST Manuel Du Propriétaire

The Controls of your
Wine Cooler
1.
Indicator light illuminates to signify the
cooling mode is currently in operation.
2. ' ' Button
To control this appliance turn ON/OFF
( press and hold this buttons for
approximately 3 seconds).
3. ' ' Button
To control the inner light turn ON/OFF.
(If you press this button, the inner
light is not controled by extrusion-board
of lamp swith, and keep lighting.)
Setting the
Temperature
NOTE
When you plug in your
wine cooler for the first
time, the temperatures
will automatically be set
to 54°F (12°C) and will be
displayed in the
Fahrenheit scale (°F).
Function
instruction
NOTE
If put in too more bottles of wine at
one time or the door is not been
closed tightly,then there may show
signal "HI"at the diapaly panel.This
is the normal phenomenon,please
wait for a while after closed the
door, "HI" will disappear.
It is normal that the the cabinet
shows "HI" or "LO" between times,
If it occurs frequently or last for a
long time, youcan get power off th-
en restart to solve it. If the problem
occurs once again after restart,
Please contract the after-sale
service for help.
Operating Instructions
4. °C / °F
Adjacent indicator light denotes which
scale of temperature is displayed.
' Button
5. '
Used to raise (warmer) the temperature
in 1° degree increments.
' ' Button
Used to decrease (cooler) the
temperature in 1° degree increments.
• To switch the display
between the Fahrenheit (°F)
and Celsius (°C) scale,
depress the and
control buttons simultaneo-
usly for approximately
five(5) seconds.
• The temperature range can
be set as low as 39°F (4°C)
or as high as 64°F (18°C) to
• • Temperature Memory Function Temperature Memory Function
In the event of a power interruption, wine cooler can remember the
previous temperature settings, and when the power is recovery,the
cabinet temperature will go back the same setting temperature as
power off.
• • Door Close Reminding Alarm Function Door Close Reminding Alarm Function
When you forget close the door or the door is not closed completely,
the buzzer alarm after 5 minutes. Please close the door completely
and advoid the cold energy was lost.
• • Temperature Alarm Function Temperature Alarm Function
If inner temperature is higher than 74°F(23°C), The "HI" is shown in
display panel, and the buzzer alarm after one hour continuously. It in-
form that the inner temperature is too high,please check the reason.
If inner temperature is lower than
display panel,and the buzzer alam.
6
°
°
suit your specific storage
requirements. Each depres-
sion of the or
ton will allow you adjust the
temperature in 1° degree
increments within the afore-
mentioned range.
34°F(1° C), The "LO" is shown in
but-