Kenwood KFC-W3000L Mode D'emploi page 8

Operation
ILLUMINATION switch
Select whether or not the illumination is used.
MODE selector
For each mode, refer
to the table described
below.
Changing the illumination mode Changing the illumination mode
On Music Mode
The On Music Mode is entered when a music signal is detected.
MODE 1 Cycle mode
Repeats MODE 2 → MODE 3 → USER → MODE 2...
Each mode changes every 20 seconds.
MODE 2 Variable mode
The illumination rotates along a circumference.
Illumination color changes depends on the signal
level.
Signal level low = Deep blue
high
You can adjust the illumination sensitivity with IN-
PUT SENSITIVITY control knob.
MODE 3 Sound Link mode
The illumination lights in synchronism with music.
Illumination color changes depends on the signal
level.
Signal level low = White
You can adjust the illumination sensitivity with IN-
PUT SENSITIVITY control knob.
USER User mode
The illumination lights in synchronism with music.
You can change the illumination color with Color
change volume. White
colors available)
Adjusting the illumination sensitivity Adjusting the illumination sensitivity
1 Control box
8
English
Color change volume
Used this knob in "USER" mode.
The color tone can be adjusted as desired.
Fully counterclockwise = White ←→ Red = Fully clockwise (Intermediate colors
available)
Red = Signal level
←→
←→ Red = Signal level high
Red (Intermediate
←→
Notes:
• It is discommended to light the illuminations when the vehicle
is moving.
• Do not stare at the illumination light for a long period.
• The illumination function may malfunction if connections
are erroneous. Be sure to connect the equipment properly by
referring to "Connection" in this manual (on page 4, 5).
Turn the MODE selector knob to select the illumi-
nation mode. Each mode (MODE 1, 2, 3 or USER)
changes depends on whether the music signal is
existing or not.
Off Music Mode
The Off Music Mode is entered when no music signal has been
input for 20 seconds.
MODE 1 Cycle mode
Repeats MODE 2 → MODE 3 → USER → MODE 2...
Each mode changes after it has been played twice.
MODE 2 Variable mode
The illumination flows from the top to the bottom.
MODE 3 Quiet mode
White lights slowly.
USER User mode
The selected color lights slowly.
You can change the illumination color with Color
change volume. White
colors available)
In the "On Music Mode", you can adjust the illumi-
nation sensitivity.
Turn the INPUT SENSITIVITY control knob using a
minus driver to adjust the illumination sensitivity
as desired.
←→ Red (Intermediate