Cellularline Interphone F3XT Manuel D'instructions page 3

4
F
g
L
6
1 - MFB (multifunction button)
2
2 - UP button
3 - DOWN button
4 - + volume button
5 - – volume button
4 8
7 - Multifunction LED
F4XT 7 - Multifunction LED
8 - Multifunction audio/data port
F3XT 9 - Mounting guides for Bluetooth® module
1 10 - Charging/audio-in connector
QUICK GUIDE EN 7
* see the user manual
3 5
for complete instructions.
8
9
A
WE RECOMMEND YOU CHECK FOR
B C
SOFTWARE UPDATES ON THE WEBSITE
WWW.INTERPHONE.CELLULARLINE.COM
www.interphone.cellularline.com
x 4
i
x 2
J
ASSEMBLY OF THE SLIDE SUPPORT
WITH REMOVABLE CLIP B
Take the support and note the best place
to fasten it to the side of the helmet. Insert
A - YELLOW
the rear part of the clip into the helmet and
attach the other part on the outside. B - GREEN
B
Insert the screws and
tighten gently. Check A
position and move the
PHASE 1 PHASE 2 support if necessary by sli-
B
ding it along. Tighten the
A
screws with the screwdri-
ver supplied.
(images A/B)
PHASE 3 PHASE 4 10
MOUNTING ON MOUNTING ON MOUNTING ON
ASSEMBLY OF THE ADHESIVE SLIDE
FULL-FACE HELMET MODULAR HELMET OPEN FACE HELMET
SUPPORT
Take the adhesive support and look for the
best side and place to position it. Clean and
de-grease the part of the helmet where you
are going to stick the support (do not use
any detergents that could damage the hel-
met's finish). Remove the
protective film from the
double sided tape, and
E
apply the support to the
helmet.
PHASE 1 PHASE 2
As the support cannot be
moved once it is attached
to the helmet, take great
care with its positioning
when applying.
(image C)
PHASE 3 PHASE 4
d
K
MOUNTING ON
FULL-FACE HELMET
A
A
MOUNTING ON
MODULAR AND
OPEN-FACE
HELMETs
A
A
M