Télécharger Imprimer la page

Liens rapides

ASSEMBLY INSTRUCTIONS
INSTRUCCIONES DE ENSAMBLAJE
INSTRUCTIONS D'ASSEMBLAGE
®
RiverRidge
Slim Cabinet with Layered Door and Drawer
®
Gabinete delgado con cajón y puertas en capas RiverRidge
Armoire mince RiverRidge
®
avec porte et tiroir à panneaux superposés
06-228 / 16-060 – White, Blanco, Blanc
RiverRidge
®
is a registered trademark of Sourcing Solutions, Inc., Hudson, WI 54016, USA
®
RiverRidge
es una marca comercial registrada de Sourcing Solutions, Inc., Hudson, WI 54016, USA
®
RiverRidge
est une marque déposée de Sourcing Solutions, Inc., Hudson, WI 54016, USA
loading

Sommaire des Matières pour RiverRidge 06-228

  • Page 1 INSTRUCTIONS D’ASSEMBLAGE ® RiverRidge Slim Cabinet with Layered Door and Drawer ® Gabinete delgado con cajón y puertas en capas RiverRidge Armoire mince RiverRidge ® avec porte et tiroir à panneaux superposés 06-228 / 16-060 – White, Blanco, Blanc RiverRidge ®...
  • Page 2 WARNING ADULT ASSEMBLY REQUIRED: This product requires assembly by an adult because of small parts. Care should be taken in unpacking and assembling this item to keep small parts away from children. During assembly children should be kept away from the product due to possible risk of injury. SERIOUS OR FATAL INJURIES CAN OCCUR FROM FURNITURE TIP-OVER.
  • Page 3 ADVERTENCIA REQUIERE QUE UN ADULTO REALICE EL ENSAMBLAJE: Este producto requiere que un adulto lleve a cabo el ensamblaje debido a las piezas pequeñas. Debe tener cuidado al desempacar y ensamblar este artículo para mantener las piezas pequeñas alejadas de los niños. Los niños deben mantenerse alejados del producto durante el ensamblaje debido al posible riesgo de lesiones.
  • Page 4 AVERTISSEMENT L’ASSEMBLAGE DOIT ÊTRE EFFECTUÉ PAR UN ADULTE : Ce produit doit être assemblé par un adulte à cause de la présence de petites pièces. Lorsque vous déballez et assemblez cet article, veillez à tenir les petites pièces hors de portée des enfants.
  • Page 5 PARTS LIST DESCRIPTION Top Board Left Side Panel Right Side Panel Cross Bar Adjustable Shelf Bottom Board Back Board Lower Front Bar Lower Left Side Bar Lower Right Side Bar Lower Back Bar Drawer Front Board Drawer Left Panel Drawer Right Panel Drawer Back Board Drawer Bottom Board Door...
  • Page 6 If you purchased your item in the United States, you can order replacement parts at no cost to you on www.riverridgehome.com. If purchased outside of the United States, please contact retailer where purchased. For any questions regarding your RiverRidge® product, please feel free to contact us at www.riverridgehome.com/pages/contact-us.contact us.
  • Page 7 STEP 1 1. Screw 1 cam bolt (A) into cam bolt hole on left side panel (2). 2. Attach 1 drawer slide (K) to left side panel (2) by inserting 3 screws (E) through screw holes on drawer slide (K), then tighten to left side panel (2). STEP 2 1.
  • Page 8 STEP 3 1. Insert 2 wood dowels (C) into wood dowel holes on cross bar (4). 2. Attach left side panel (2) and right side panel (3) to cross bar (4) by inserting cam bolts (A) into cam bolt holes on cross bar (4) and inserting wood dowels (C) into wood dowel holes on left side panel (2) and right side panel (3).
  • Page 9 STEP 5 1. Attach top board (1) to left side panel (2) and right side panel (3) by inserting 4 cam bolts (A) into cam bolt holes on left side panel (2) and right side panel (3). 2. Insert 4 cam locks (B) into cam lock holes on left side panel (2) and right side panel (3), then rotate clockwise to secure cam bolts (A) in place.
  • Page 10 STEP 7 1. Insert 4 wood dowels (C) into wood dowel holes on left side panel (2) and right side panel (3). 2. Attach bottom board (6) to left side panel (2) and right side panel (3) by inserting wood dowels (C) into wood dowel holes on bottom board (6).
  • Page 11 STEP 9 1. Insert 2 wood dowels (C) into wood dowel holes on lower back bar (11). 2. Attach lower left side bar (9) and lower right side bar (10) to lower back bar (11) by inserting cam bolts (A) into cam bolt holes on lower back bar (11) and by inserting wood dowels (C) into wood dowel holes on lower left side bar (9) and lower right side bar (10).
  • Page 12 STEP 11 1. Insert 4 wood dowels (C) into wood dowel holes on bottom board (6). 2. Attach pre-assembled unit to bottom board (6) by inserting cam bolts (A) into cam bolt holes on lower left side bar (9) and lower right side bar (10) and by inserting wood dowels (C) into wood dowel holes on lower front bar (8) and lower back bar (11).
  • Page 13 STEP 13 OPTION #1 DRYWALL WALL ANCHOR WITH SCREW OPTION #2 DRYWALL WOOD STUD SCREW ONLY Option #1: Securing to Drywall 1. Position cabinet against wall in desired location. Using a pencil, make 1 small mark on wall through hole on adjustable anchor bracket (J). Move cabinet away from wall and screw 1 plastic wall anchor (O) into wall on pencil mark.
  • Page 14 STEP 14 1. Insert 4 shelf holders (H) into holes on left side panel (2) and right side panel (3). Make sure 4 shelf holders (H) are at the same level. 2. Place adjustable shelf (5) onto shelf holders (H). STEP 15 1.
  • Page 15 STEP 16 See Adjustable Hinge instructions below Note: Tightening screw in position “a” will adjust door up or down; tightening screw in position “b” will adjust door to or from cabinet and tightening screw in position “c” will adjust door side to side. 1.
  • Page 16 STEP 17 1. Screw 4 cam bolts (A) into cam bolt holes on drawer front board (12). 2. Attach 1 knob (M) to drawer front board (12) by inserting 1 machine screw (L) through hole on drawer front board (12), then tighten to knob (M). 3.
  • Page 17 STEP 19 1. Slide drawer into cabinet by sliding drawer slides (K) into grooves on the drawer left panel (13) and drawer right panel (14). Pull drawer out and adjust drawer slides (K) to be fully extended against drawer front board (12). Insert 2 machine screws (Q) through holes on drawer left panel (13) and drawer right panel (14), then tighten to drawer slides (K).
  • Page 18 CARE INSTRUCTIONS: Wipe clean with a water dampened cloth. Wipe dry with clean cloth. IMPORTANT: Keep assembly instructions for future reference. LET’S GET SOCIAL! Follow us and tag @riverridgehome in your photos and videos of your RiverRidge products! ®...
  • Page 19 LISTA DE PIEZAS N.° DESCRIPCIÓN CANT. Tablero superior Panel izquierdo Panel derecho Barra transversal trasera Repisa adjustable Tablero inferior Tablero trasero Barra inferior delantera Barra lateral inferior izquierda Barra lateral inferior derecha Barra trasera inferior Tablero delantero del cajón Panel izquierdo del cajón Panel derecho del cajón Tablero trasero del cajón Tablero inferior del cajón...
  • Page 20 Si compró el producto en los Estados Unidos, puede pedir las piezas de repuesto sin costo en www.riverridgehome.com. Si lo compró fuera de los Estados Unidos, comuníquese con el distribuidor donde lo adquirió. Si tiene preguntas con relación a este producto RiverRidge® no dude en comunicarse con nosotros a través de www.riverridgehome.com/pages/contact-us.
  • Page 21 PASO 7 1. Introduzca 4 pasadores de madera (C) en los orificios para pasadores de madera del panel izquierdo (2) y del panel derecho (3). 2. Fije el tablero inferior (6) al panel lateral izquierdo (2) y al panel lateral derecho (3) insertando pasadores de madera (C) en los orificios de pasadores de madera en el tablero inferior (6).
  • Page 22 PASO 13 Opción n.º 1: Fijar a una pared de yeso 1. Ubique el gabinete contra una pared en el lugar deseado. Con un lápiz, haga 1 marca pequeña en la pared a través del orificio del soporte de anclaje ajustable (J). Aleje el armario de la pared y atornille 1 anclaje de plástico para pared (O) en la pared sobre la marca que hizo con el lápiz.
  • Page 23 INSTRUCCIONES DE CUIDADO: Limpiar con un paño humedecido en agua. Secar con un paño limpio. IMPORTANTE: Guarde las instrucciones de ensamblaje para futuras referencias. ¡SOCIALICEMOS! ¡Síganos y etiquete a @riverridgehome en las fotos y videos de sus productos RiverRidge®!
  • Page 24 LISTE DES PIÈCES N° DESCRIPTION QTÉ Plaque supérieure Panneau latéral gauche Panneau lateral droit Barre transversal arrière Étagère réglable Plaque inférieure Plaque arrière Barre inférieure avant Barre latérale inférieure gauche Barre latérale inférieure droite Barre inférieure arrière Plaque avant du tiroir Panneau lateral gauche de tiroir Panneau lateral droit de tiroir Plaque arrière du tiroir...
  • Page 25 Si l’achat est effectué en dehors des États-Unis,veuillez contacter le détaillant où vous avez acheté. Pour toute question concernant votre contrat RiverRidge® n’hésitez pas à nous contacter à l’adresse www.riverridgehome.com/pages/contact-us. ÉTAPE 1 1.
  • Page 26 ÉTAPE 7 1. Insérez 4 goujons en bois (C) dans les trous prévus à cet effet du panneau latéral gauche (2) et du panneau latéral droit (3). 2. Fixez la planche inférieure (6) au panneau latéral gauche (2) et au panneau latéral droit (3) en insérant des goujons en bois (C) dans les trous de la planche inférieure (6) prévus à...
  • Page 27 ÉTAPE 13 Option 1: Fixation sur des cloisons sèches 1. Placez l’armoire contre le mur à l’endroit désiré. À l’aide d’un crayon, faites 1 petite marque sur le mur à travers le trou du support d’ancrage réglable (J). Éloignez l’armoire du mur et visser 1 ancrage mural en plastique (O) dans le mur sur la marque de crayon.
  • Page 28 INSTRUCTIONS D’ENTRETIEN: Nettoyez avec un chiffon humide. Séchez avec un chiffon propre. IMPORTANT : Conservez les instructions d’assemblage pour toute référence ultérieure SOCIALISONS-NOUS! Suivez-nous et marquez @riverridgehome dans vos photos et vidéos de vos produits RiverRidge®...

Ce manuel est également adapté pour:

16-060