Acksys AirLink V2 Guide D'installation Rapide page 29

None of the LED indicators turns ON

Check the power supply (voltage, cabling).
The relevant LAN led indicator stays OFF

Check that the remote device is turned ON.

Check the Ethernet plugs on both sides.

Try to connect to another device.

Use the provided RJ45 cable to connect the device.
The Wi-Fi link does not come up

Make sure that the Wi-Fi interface is enabled

Make sure that the Wireless parameters of the Client (case sensitive SSID, 802.11
mode, radio channel and security) match those of the AP.

Check the radio conditions: distance between devices, placement of antennas,
interferences and obstacles to radio waves propagation.

Try with all securities and encryption settings temporarily disabled.

Try using the product with factory settings as shown in the "Quickly evaluate..."
section.

Try another radio channel.
"WaveManager" doesn't find your device

WaveManager only scans the local network. To reach a device through a gateway,
use the "fileremote products database" function.

Check that your firewall does not block WaveManager.
How to restore factory settings

If the built-in web-based interface is reachable, you can use your browser to restore
factory settings.

Else, power up the unit, wait for the red "Diag" LED to turn green, then hold down
the reset button (for at least 2 seconds) until "Diag" goes red. Then release it and
wait for the Diag LED to turn green again, meaning that the product rebooted with
its factory settings.
TROUBLESHOOTING
-9-