MediaShop NuBreeze Mode D'emploi page 6

STEP 4: Fitting the frame
Push the vertical base tubes (H) through the side rods of the motor unit.
I
Place the assembled motor on the feet (D) and press down the vertical
B
1
base tubes (H) to secure.
COMMENT TO FIX THE HANGERS:
Push the middle connecting piece (B) individually onto the vertical base
tube (H). LIGHTLY fix it with the holders (I).
BEFORE TIGHTENING THE HOLDERS, PERFORM STEP 4.
H
D
I
B
2
STEP 5:
Slide the vertical tubes (J) into the vertical base tubes (H).
HANGER (1): Slide the middle connectors (B) one by
L
one onto the vertical base tube (H) and tighten lightly
with the fasteners (I).
HANGER (2): Slide the middle connectors (B) one
by one onto the vertical tube (J) and tighten fully
with the fasteners (I).
J
NOTE: Once the two vertical tubes are connected,
the hanger (1) can be attached.
I C
Attaching the smart hanger (L):
1
The smart hanger can be attached on either side
of the upper vertical tubes. (When attaching the
smart hanger, insert the bottom part first and hang
the top part, then pull it down to secure.)
H
Racks easily adjustable to several positions!
PLEASE BEAR OUR TIPS IN MIND
FOR OPTIMAL RESULTS:
www.mediashop.tv/nubreeze
6