Unpack Generator; Install Wheel Kit - Milwaukee 4943-24 Manuel D'utilisateur

Your generator requires some assembly and is ready for use
after it has been properly serviced with the recommended
fuel and oil.
If you have any problems with the assembly of your generator,
please call the generator helpline at 1-00-SAwDUST
(1-00-29-3). If calling for assistance, please have the
model, revision, and serial number from the data tag available.
See Generator Controls and Features for data tag location.

Unpack Generator

1. Set the carton on a rigid, flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by carefully cutting each corner
from top to bottom.
4. Leave generator on carton to install wheel kit.
The generator is supplied with:
• Engine oil bottle
• Operator's manual
• Wheel kit
If any parts are missing or damaged, please call the generator
helpline at 1-00-SAwDUST (1-00-29-3).

Install wheel Kit

The wheel kit is designed to greatly improve the portability of
your generator.
NOTE: Wheel kit is not intended for over-the-road use.
You will need the following tools to install these
components:
• 1/2" open end wrench
b
c
D
Assembly
A
F
G
E
• Pliers
• Safety glasses
Install the wheel kit as follows:
1. Tip generator so that engine end is up.
2. Slide axle (A) through both mounting brackets.
3. Slide a wheel (b) over axle.
NOTE: Be sure to install wheel with raised hub inboard.
4. Place a washer (c) on axle and then place an e-ring (D)
in axle groove.
E-rings can cause eye injury.
E-rings can spring back and become airborne
when installing or removing.
• Always wear eye protection when installing/removing e-rings.
5. Install e-ring with pliers, squeezing from top of e-ring
to bottom of axle.
6. Repeat steps 3 through 5 to secure second wheel.
7. Tip generator so that engine side is down.
8. Line up holes in support leg (E) with holes in generator
frame.
9. Attach support leg using 4 carriage bolts (5/16-18 x
.75) (F) and 4 lock hex nuts (G). Tighten with a 1/2"
open end wrench.
10. Return generator to normal operating position (resting
on wheels and support leg).
F
G
cAUTION
D
c
b
9