Replacing The Lamp - EuroLite DMX SUPERSTROBE 2700 Mode D'emploi

There are no serviceable parts inside the device except for the lamp. Maintenance and service operations
are only to be carried out by authorized dealers.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged (cable firmly connected with the device), it has to
be replaced by authorized dealers only in order to avoid hazards.
If the power supply cable of this device becomes damaged (replaceable cable), it has to be replaced by a
special power supply cable available at your dealer.
Should you have further questions, please contact your dealer.

Replacing the lamp

Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need one XOP-15 flash tube.
During the operation, the lamp reaches temperatures of up to 550° C.
Procedure:
Step 1: Unscrew the fixation screws of the protective shield.
Step 2: Remove the protective shield.
Step 3: Remove the old lamp from the lamp-socket.
Step 4: Insert the new XOP-15 flash tube lamp into the lamp-socket.
Step 5: Replace the protective shield and tighten the screws.
DANGER TO LIFE!
Only install the lamp with the device switched off!
Unplug from mains before!
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
Do not operate this device with opened protective shield!
18