Front Panel - Real Cable HDD14b Manuel D'utilisation

HDD14b_Manual_French_English_1_0.doc
4. Operation

4.1. . Front Panel

HDMI
Output
®
Real Cable
HDMi 1.3
1
1. HDMI output 1 Connect to the HDMI input of your display.
2. HDMI input: Connect to the HDMI or DVI output of your source equipment such as Blu-ray
player, DVD, HD Satellite receiver, PC....
3. EDID Control Switch: Default factory setting is TV, leave as is if the displays are working
properly. Switch to STD to use built-in EDID if the displays have problems. When the EDID control
switch is in TV selection, the unit will detect the first HDMI output display's EDID and record it in
the unit. If the first detected output display is DVI, it will pass to next display, until the first HDMI is
detected
4. Sync LED: The LED will illuminate when the HDMI source signal is connected to the input.
5. Power LED: The LED will illuminate when the power supply is connected
6. Power input: Plug the supplied 5VDC power supply into the unit.
.
4.2. . Rear Panel
1. HDMI output 2/3/4: Connect each of these output ports to the HDMI input
of a HDMI display.
Sync. POWER DC 5V
HDMI
Intput
EDID
TV
STD
2 3 4 5
5/12
6
®
Real Cable