iHealth PO3 Mode D'emploi page 6

iHealth Cloud account by using your app login name and password. Go to
www.ihealthlabs.com, then click on "Sign In".
Turn Bluetooth "On"
Your iHealth Wireless Pulse Oximeter uses Bluetooth 4.0 Low Energy (BLE) technology.
Enable the Bluetooth on your iOS device (Settings->General->Bluetooth->On), launch
the app to initiate the connection. The Bluetooth icon will light up and stop ashing
when a successful connection is established. The date and time of the Pulse Oximeter
will be synced with your iOS device upon rst successful connection.
TESTING INSTRUCTIONS
1. Open the clamp of the Pulse Oximeter, then place your
middle, ring or index nger of your left hand into the
rubber opening of the oximeter with nail side down, as
pictured.
2. On the front panel, press the "Start" button once to turn the oximeter on.
3. Keep your hand still for the reading.
4. After a few seconds, your SpO2 reading will appear on the oximeter display screen
and the app if the app is turned on.
5. If the signal strength is too low, switch to another nger and perform the test again.
USING WITHOUT iOS DEVICE
After it has been used for the rst time, the date and time of the Pulse Oximeter will be
synchronized with your iOS device. It can also be used without being connected to an
iOS device. In this case, the measurement data is stored in memory and can be
uploaded to the app when the connection is re-established. The Pulse Oximeter can
4