BEFORE CALLING FOR SERVICE
If the grill does not function properly, use the following check list before contacting your dealer for
service. You may save the cost of a service call.
PROBLEM
When attempting to light my grill, it will not
light immediately.
Regulator makes noise.
Full size cover does not fit the grill.
SOLUTION
• Make sure you have a spark while you are trying to light
the burner (if no spark)
• Ensure that the wire is connected to the electrode
assembly.
• Clean wire (s) and / or electrode with rubbing alcohol
and a clean swab. Wipe with a clean cloth.
• Check to see if the other burners operate. If so, check the
gas orifice on the malfunctioning burner for an obstruction.
• Vent hose on the regulator may be plugged or regulator
may be faulty.
• Ensure the vent hole on the regulator is not obstructed.
Clear the hole, close the gas control valves. Wait ten
minutes and re-start.
• Check your flames for proper performance. If the flames
are not correct, replace regulator.
• Cover may be incorrect for your grill. It may be a tight fit.
Ensure the cover is the correct length for your grill.
Measure it left to right. Compare to the grill's
measurement.
• Compare the location and size of the hood portion of the
cover to your grill.
• Spread the cover and allow it to relax, preferably in warm
sunlight or in a warm room.
• For grill with a side shelf, put on left to right.
Troubleshooting
continued
22