LENCO BMC-060 Mode D'emploi page 4

9. Do not use this device when condensation may occur. When the unit is used
in a warm wet room with damp, water droplets or condensation may occur
inside the unit and the unit may not function properly; let the unit stand in
power OFF for 1 or 2 hours before turning on the power: the unit should be
dry before getting any power.
10. Although this device is manufactured with the utmost care and checked
several times before leaving the factory, it is still possible that problems may
occur, as with all electrical appliances. If you notice smoke, an excessive
build-up of heat or any other unexpected phenomena, you should disconnect
the plug from the main power socket immediately.
11. This device must operate on a power source as specified on the specification
label. If you are not sure of the type of power supply used in your home,
consult your dealer or local power company.
12. Keep away from animals. Some animals enjoy biting on power cords.
13. To clean the device, use a soft dry cloth. Do not use solvents or petrol based
fluids.
To remove severe stains, you may use a damp cloth with dilute detergent.
14. The supplier is not responsible for damage or lost data caused by malfunction,
misuse, modification of the device or battery replacement.
15. Do not interrupt the connection when the device is formatting or transferring
files. Otherwise, data may be corrupted or lost.
16. If the unit has USB playback function, the USB memory stick should be
plugged into the unit directly. Don't use an USB extension cable because it can
cause interference resulting in failing of data.
17. The rating label has been marked on the bottom or back panel of the device.
18. This device is not intended for use by people (including children) with
physical, sensory or mental disabilities, or a lack of experience and
knowledge, unless they're under supervision or have received instructions
about the correct use of the device by the person who is responsible for their
safety.
4