Getting Started - Lindemann Limetree Headphone Mode D'emploi

14 EN

GETTING STARTED

Using your line cables, connect each of your sources to one input
on the headphone amp. If required, connect the output labeled
with "Output" to the input of your power amplifier or active speak-
ers. Insert the headphone plug into the headphone socket on the
front of the device. Insert the wall plug transformer into the "5V
DC" supply socket. Now plug the power supply into a mains outlet.
To be on the safe side, turn down the amplifier volume first.
Now turn on the headphone preamp by briefly pushing up once
the switch on the front panel. A yellow LED will indicate the se-
lected input. By pushing and holding the switch for a longer time
(3 seconds) you can change between the inputs. Pushing up the
switch again briefly will turn the unit off.
Now raise the volume level and you're done! Your new headphone
amp is ready for running.