Product Overview - AEG ML 3 Mode D'emploi

14

Product Overview

13
12
1
2
1. Floodlight
2. Covering
3. Ratchet knob
4. Handle (swivel connection)
5. On/Off switch for headlamp
6. Casing
7. Reading light / Flashing warning
light (red)
4
3
5
9
10
11
8. Storage compartment
9. Charging socket
10. Charge display control light
11. On/Off switch for reading light and
flashing warning light (red)
12. 12 V vehicle charging cable
13. 230 V charging mains adapter
USE
Please check the re every use for possible damage. Never use a damaged product.
Charging
Charge the battery fully before initial use. when the battery is completely charged, the
Vehicle Multilight is ready to use.
1. Remove the Covering [2].
2. Plug the selected charging cable into the Charging socket [9] of the Vehicle Multi-
light.
3. Plug the 230 V Charging mains adapter [13] into the mains or the Vehicle charging
cable [12] into a 12 V vehicle socket.
4. Remove the charging cable when the battery has been fully charged (this will be
6
indicated by the Charge control light [10]). warning: Lengthy charging via a 12 V
vehicle socket will run the vehicle battery down!
7
5. Replace the Covering [2].
Charge display control light [10] (red):
8
▪
Lights up when the battery is being charged
▪
Switches off when the charging process is complete and the battery is fully charged.
Switching the Headlamp on or off:
Press the On/Off switch [5] on the Handle [4].
Switching the Reading light on:
Remove the Covering [2].
Switch the On/Off switch [11] to Position II.
Replace the Covering [2].
Switching the Flashing warning light on:
Remove the Covering [2].
Switch the On/Off switch [11] to Position I.
Replace the Covering [2].
Switching the Reading light / Flashing warning light off:
1. Remove the Covering [2].
2. Switch the On/Off switch [11] to Position 0.
3. Replace the Covering [2].
GB
15