Microwave Oven Control; Display; Start; Off Cancel - Inglis IRH320 Guide D'utilisation Et D'entretien

When power is first supplied to the microwave oven, a ":" will
blink in the display. Touch OFF CANCEL to stop the blinking.
If the ":" blinks in the display at any other time, a power failure
has occurred. Touch OFF CANCEL and reset the clock if needed.
If "RETRY" blinks in the display for 1 second, an invalid value has
been entered. Retry your entry.
When the microwave oven is in use, the display shows cooking
power, quantities, weights and/or prompts. When the microwave
oven is not in use, the display shows the time of day or Timer
countdown.
The START pad begins any function. If not touched within
5 seconds after touching a pad, "START?" will appear on the
display as a reminder. If not touched within 1 minute after
touching a pad, the display will return to the time of day mode
and the programmed function will be canceled.
If cooking is interrupted, touching START will resume the preset
cycle.
6

MICROWAVE OVEN CONTROL

Display

Start

Off Cancel

The OFF CANCEL pad stops most functions except for the Timer,
Control Lock and Demo Mode.
The microwave oven will also turn off when the door is opened.
Close the door and touch START to resume the cycle.

Add Minute

Cook time may be added in 1-minute increments, up to
99 minutes, by touching ADD MINUTE.
Touching ADD MINUTE during a cook cycle will add 1 minute of
cook time at the current cook power.
Touching ADD MINUTE when the microwave oven is not in use,
or after a cook cycle has ended, will start the microwave oven for
1 minute of cook time at 100% cook power.
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
The microwave oven and timer must be off.
1. Touch CLOCK.
2. Touch the number pads to set the time of day.
3. Touch CLOCK or START.
To Remove:
1. Touch CLOCK.
2. Touch 0.
3. Touch CLOCK.
The time will disappear, and ":" will appear on the display.
Tones are audible signals, indicating the following:
One tone
Valid entry (short tone)
End of Timer countdown (long tone) (on some models)
Two tones
End of stage in multistage cooking
Reminder, repeat each minute after the end-of-cycle tones
Control Lock active
Hidden feature has been entered or exited
Three tones
Invalid entry
Four tones
End of cycle
To Turn Off/On Valid Entry Tones: Touch and hold the number
pad "1" for 5 seconds until 2 tones sound. Repeat to turn tones
back on.
To Turn Off/On All Tones: Touch and hold the number pad "2"
for 5 seconds until 2 tones sound. Repeat to turn tones back on.

Clock

Tones