Warranty Disclaimer - Hama GS 558 Mode D'emploi

Diagram 2
17. Installation
• Fix the two AA batteries to each battery box of the
smoke alarm.
• According to the "Wireless function description"
Section to operate the smoke alarm. Ensure the wireless
function is ok.
• Then press the bracket on the installation position, mark
installation hole of bracket with pencil.
• Bore two installation holes on the sign with electric drill.
Make diameter of holes is 5 mm, Strike the two plastic
plugs into holes with hammer.
• Attach the bracket to the plastic plugs and fix tightly
the screws (3*25 mm) into the plastic plugs. (refer to
Diagram 3).
• Fit the alarm on the bracket and turn the alarm body
lockwise, until matching well on the bracket.
• Test smoke alarm using test button. The alarm will sound
3 short beeps – 1.5 seconds pause, then repeat it until
release the button.
• If no sound, it indicates a defective alarm, you can refer
to "Trouble shooting" for solution or return to your
retailer during warranty.
• If you have any questions on installation, you can contact
your retailer.
• During testing, may the other smoke detector will alarm.
Once release the button, others will stop alarming in
1 minute. In such a way, you can check the wireless
function.
Warning
To prevent injury, this unit must be securely attached
to the ceiling in accordance with the installation
instructions.
6
50 cm
100 cm
Diagram 3
Holes of ceiling or wall
bracket
Alarm body

18. Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
19. Service and Support
Please contact Hama Product Consulting if you have any
questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
plastic plugs
Two screws
(3*25 mm)