Aligning The Exhaust Flap; Using The Timer Function - Exquisit LE 2055 wes Mode D'emploi

• Do not switch the dehumidifier off
during the de-icing process and do
not disconnect it from the mains.
• During the de-icing process the
dehumidifier will stop the
dehumidifying function but the fan
will remain in operation.
• The lower the ambient
temperature, at which you operate
the dehumidifier is, the more likely
and/or frequently the de-icing
function will be activated.
•
Once the de-icing process is
completed the dehumidifier will
continue to function in the previously
selected operating mode. Please note
that the dehumidifying process will
run again with a delay of approx. 3
minutes only to prevent overheating
of the dehumidifier or of the
compressor.

15.2 Aligning the exhaust flap

• Do not completely close the
exhaust flap at the air
discharge opening under any
circumstances while you are
operating the dehumidifier.
• You can align the exhaust flap
(1) at the air discharge
opening in 5 stages (small
opening to maximum opening)
in order to guide the air that is
being discharged in a certain
direction, e.g. towards laundry
that is being dried (see figs. A
and C).
ATTENTION
Danger of damage!
If the dehumidifier is handled
improperly, you can
damage it.
Operating functions

15.3 Using the timer function

The dehumidifier possesses a
timer function, with which you
can pre-set the desired running
time (in hours). Upon expiration
of the operating time the
dehumidifier will switch itself off
automatically.
1. Press key 21 (see fig. C) The
running time that was set
most recently will blink in the
display.
2. While the display is blinking,
you can set the running time
as described in step 2.
3. If you make no adjustment,
4. the display will change back to
the current air humidity.
5. Press the key + or - once or
several times, in order to set
the running time (in hours).
6. For a few seconds the
adjusted running time will
blink in the display.
7. Subsequently, the display will
change back again to showing
the current air humidity.
8. The control light above the
Timer button 21 (on) is lit up
constantly while the timer
function is active.
9. Press button 21 in order to
have the remaining running
time of the timer function
displayed.
10. The remaining running time
will blink in the display. After a
few seconds the display will
change back again to show
the current air humidity.
11. Press button 21 a second
time while the remaining
running time is blinking in the
display in order to switch the
timer function off before the
set time period has expired.
Page | 33