Before Starting - Ex-Tech XY2WCE1A250 Mode D'emploi

For a more secure mounting, the trip wire switch must always be in a horizontal position on a flat surface.
a) Find the final location of the device
b) Make the electrical connections
c) Make the ground connection of the housing
d) Set trip wire switch
e) Check the operation of the device
If there is malfunction, check the connection, if the problem persists, check the
product by persons qualified and authorized

9. Before starting

 Make sure the unit has been correctly settled and not damaged
 Make sure the wiring and the tightening of the connections have been performed properly
 The device may include any foreign body and no part is damaged
 The cable gland must be tightened
10. Maintenance
The maintenance and repairs works on devices must be made only by authorized and trained persons for
that purpose.
Before any technical intervention the devices must be switched off.
It is also necessary to observe the regulations in the country of use.
 Prevent and avoid any formation of layers of dusts: make a periodic cleaning with a wet cloth
 Check tightness of the connections, rewire if necessary
The following checks must be made at least once a year:
 The outdoor equipment and surfaces must not be damaged
 The cable entries and blanking plugs must be threaded
 Check tightness of the connections, rewiring if necessary
 Check all accessories (labels, ground nut, cable status, ...)
XY2004A12-07 01/12/2016
Operating instructions
Trip wire switch - XY2W series
ENG
12/16