Hisense RC16A1GBE Manuel De Fonctionnement De L'utilisateur page 7

door
bottom feet
Open the refrigerator door and remove all fittings inside the door.
Remove the upper hinge cover
Remove the two screws
Carefully lift the door and place it on a padded surface to prevent scratching.
Remove the screw hole cover ⑧ .
Remove the two screws ⑥ that hold the lower hinge ⑤ on the right side of the cabinet.
Remove the bottom feet ⑦ and transfer it to the right side of the cabinet.
Set the door into its new place making sure the pin enters the bushing at the lower frame section (hole).
Secure the upper hinge
ure the pin enters the bushing on the upper frame section (hole).
Loosely secure the lower hinge ⑤ and do not tighten the bolts until the door is in the closed
position and leveled.
Replace the upper hinge cover
Turn the door upright again.
Open the door and attach all fittings.
lower hinge
screw hole cover
.
that connect the upper hinge
previously removed in step 4 on the left side of the unit. Make s
.
special flange self-tapping screw
on the right side of the ca top.