Connection Settings; English - Genius Gx Gaming Speedmaster X2 Guide Rapide

Connection Settings:

Pedal USB: Connect to the "C" slot in the wire storage box behind the steering wheel.
Gear Shifter Stick USB: Connect to the "B" slot in the same storage box.
Steering Wheel Main USB: Connect to the USB port of Gaming Platform.
Note: An original controller required for guiding SpeedMaster series connected to consoles
successfully.
For PC: Default to Directinput mode with a red-light indicator upon successful connection. Press the
PS button for about 3 seconds to cycle switch between Xinput mode and XBOX-ONE mode.
For PS3: With a red light upon successful connection.
Note:
 PC's Xbox One mode works primarily on Windows 10/11.
 After connecting to PC, press "Reset" for 5 seconds and then rotate fully left and right to calibrate
the wheel.
SpeedMaster (Series), besides supporting PC games, is also compatible with multiple gaming
platforms, including PS4, Xbox-Series S/X, Xbox One, Xbox 360. Connect each console's original
controller to the "D" slot behind the wheel to guide SpeedMaster (Series) the primary controller.
For PS4: Connect a power- off PS4 wireless controller via USB to the "D" slot behind the wheel,
then connect the wheel to the PS4's USB port. A blue light indicates a successful connection. Note:
The PS4 controller must be off for successful pairing.
For Xbox Series/Xbox One: Connect an Xbox-Series X controller, with batteries removed, via USB
to the "D" slot on the wheel's back, then connect the wheel to the Xbox's USB port. A light blue light
on the wheel and a steady light on the controller indicate success. Ensure the controller is off or
battery-free before connecting for successful pairing.
For Xbox 360: Plug an original wired Xbox 360 controller into the wheel's "D" slot and then connect
the wheel to the Xbox 360. A light green on the wheel and a lit controller light indicate success. Note:
Only original wired controller is compatible.
Special Functions:
 Clear the angle setting: long-press "Angle" for 5 seconds until the LED blinks fast to clear the angle setting.
 Clear the replacement function: Clear swaps by holding Replace for 5 seconds until the LED blinks fast.
Reset function: Long-press for 5 seconds to clear angle and button settings, indicated by blinking LED.

Angle function: Setting for the steering wheel's range of
turning angle.
To set the steering wheel angle to 900 degrees, for
instance, long-press "Angle" until the blue LED blinks
slowly. Rotate left to 900 degrees, press "Angle" to lock,
and the LED will return to normal. Repeat to the right for
900 degrees and lock. The steering wheel only locks at
angles over 90 degrees; below this, it defaults to 90
degrees.
Replace function: Allows swapping the functions of action
buttons (A/B/X/Y/L3/R3/L1/R1),
(accelerator/brake/clutch (optional)), and gear shifter
(high/low) on the steering wheel.
To swap functions, like the left trigger with the A button:
Long-press Replace until the blue LED lights, press the left
trigger (LED blinks), then press A (LED off). The swap is
done. If inactive for 60 seconds, it exits replacement mode.
4

English

pedals